Ostwald ripening

Basic schematic of the Ostwald ripening process

Ostwald ripening is an observed phenomenon in solid solutions or liquid sols that describes the change of an inhomogeneous structure over time, i.e., small crystals or sol particles dissolve, and redeposit onto larger crystals or sol particles.^[1]

Dissolution of small crystals or sol particles and the redeposition of the dissolved species on the surfaces of larger crystals or sol particles was first described by Wilhelm Ostwald in 1896.^[2][3] Ostwald ripening is generally found in water-in-oil emulsions, while flocculation is found in oil-in-water emulsions.^[4]

Mechanism

This thermodynamically-driven spontaneous process occurs because larger particles are more energetically favored than smaller particles.^[5] This stems from the fact that molecules on the surface of a particle are energetically less stable than the ones in the interior.

Cubic crystal structure (sodium chloride)

Consider a cubic crystal of atoms: all the atoms inside are bonded to 6 neighbors and are quite stable, but atoms on the surface are only bonded to 5 neighbors or fewer, which makes these surface atoms less stable. Large particles are more energetically favorable since, continuing with this example, more atoms are bonded to 6 neighbors and fewer atoms are at the unfavorable surface. As the system tries to lower its overall energy, molecules on the surface of a small particle (energetically unfavorable, with only 3 or 4 or 5 bonded neighbors) will tend to detach from the particle, as per the Kelvin equation, and diffuse into the solution. When all small particles do this, it increases the concentration of free molecules in solution. When the free molecules in solution are supersaturated, the free molecules have a tendency to condense on the surface of larger particles.^[5] Therefore, all smaller particles shrink, while larger particles grow, and overall the average size will increase. As time tends to infinity, the entire population of particles becomes one large spherical particle to minimize the total surface area.

The history of research progress in quantitatively modeling Ostwald Ripening is long, with many derivations.^[6] In 1958, Lifshitz and Slyozov ^[7] performed a mathematical investigation of Ostwald ripening in the case where diffusion of material is the slowest process. They began by stating how a single particle grows in a solution. This equation describes where the boundary is between small, shrinking particles and large, growing particles. They finally conclude that the average radius of the particles ⟨R⟩, grows as follows:

where

	=	average radius of all the particles
	=	particle surface tension or surface energy
	=	solubility of the particle material
	=	molar volume of the particle material
	=	diffusion coefficient of the particle material
	=	ideal gas constant
	=	absolute temperature and
	=	time.

Note that the quantity ⟨R⟩³ is different from ⟨R³⟩, and only the latter one can be used to calculate average volume, and that the statement that ⟨R⟩ goes as t^1/3 relies on ⟨R⟩₀ being zero; but because nucleation is a separate process from growth, this places ⟨R⟩₀ outside the bounds of validity of the equation. In contexts where the actual value of ⟨R⟩₀ is irrelevant, an approach that respects the meanings of all terms is to take the time derivative of the equation to eliminate ⟨R⟩₀ and t. Another such approach is to change the ⟨R⟩₀ to ⟨R⟩_i with the initial time i having a positive value.

Also contained in the Lifshitz and Slyozov derivation is an equation for the size distribution function f(R, t) of particles. For convenience, the radius of particles is divided by the average radius to form a new variable, ρ = R(⟨R⟩)⁻¹.

Three years after that Lifshitz and Slyozov published their findings (in Russian, 1958), Carl Wagner performed his own mathematical investigation of Ostwald ripening,^[8] examining both systems where diffusion was slow and also where attachment and detachment at the particle surface was slow. Although his calculations and approach were different, Wagner came to the same conclusions as Lifshitz and Slyozov for slow-diffusion systems. This duplicate derivation went unnoticed for years because the two scientific papers were published on opposite sides of the Iron Curtain in 1961. It was not until 1975 that Kahlweit addressed the fact that the theories were identical^[9] and combined them into the Lifshitz-Slyozov-Wagner or LSW Theory of Ostwald ripening. Many experiments and simulations have shown LSW theory to be robust and accurate. Even some systems that undergo spinodal decomposition have been shown to quantitatively obey LSW theory after initial stages of growth.^[10]

Wagner derived that when attachment and detachment of molecules is slower than diffusion, then the growth rate becomes

where k_s is the reaction rate constant of attachment with units of length per time. Since the average radius is usually something that can be measured in experiments, it is fairly easy to tell if a system is obeying the slow-diffusion equation or the slow-attachment equation. If the experimental data obeys neither equation, then it is likely that another mechanism is taking place and Ostwald ripening is not occurring.

Although LSW theory and Ostwald ripening were intended for solids ripening in a fluid, Ostwald ripening is also observed in liquid-liquid systems, for example, in an oil-in-water emulsion polymerization.^[4] In this case, Ostwald ripening causes the diffusion of monomers (i.e. individual molecules or atoms) from smaller droplets to larger droplets due to greater solubility of the single monomer molecules in the larger monomer droplets. The rate of this diffusion process is linked to the solubility of the monomer in the continuous (water) phase of the emulsion. This can lead to the destabilization of emulsions (for example, by creaming and sedimentation).^[11]

Specific examples

Oil droplets in pastis mixed with water grow by Ostwald ripening.

An everyday example of Ostwald ripening is the re-crystallization of water within ice cream which gives old ice cream a gritty, crunchy texture. Larger ice crystals grow at the expense of smaller ones within the ice cream, creating a coarser texture.^[12]

Another gastronomical example is in the ouzo effect, where the droplets in the cloudy microemulsion grow by Ostwald ripening.

In geology, it is the textural coarsening, aging or growth of phenocrysts and crystals in solid rock which is below the solidus temperature. It is often ascribed as a process in the formation of orthoclase megacrysts,^[13] as an alternative to the physical processes governing crystal growth from nucleation and growth rate thermochemical limitations.

In chemistry, the term refers to the growth of larger crystals from those of smaller size which have a higher solubility than the larger ones. In the process, many small crystals formed initially slowly disappear, except for a few that grow larger, at the expense of the small crystals. The smaller crystals act as fuel for the growth of bigger crystals. Limiting Ostwald ripening is fundamental in modern technology for the solution synthesis of quantum dots.^[14] Ostwald ripening is also the key process in the digestion of precipitates, an important step in gravimetric analysis. The digested precipitate is generally purer, and easier to wash and filter.

Ostwald ripening can also occur in emulsion systems, with molecules diffusing from small droplets to large ones through the continuous phase. When a miniemulsion is desired, an extremely hydrophobic compound is added to stop this process from taking place.

See also

• Rock microstructure
• Kelvin equation
• Kirkendall effect
• Critical radius
• Solubility equilibrium#Particle size effect
• Flocculation
• Aggregation
• Coalescence (chemistry)
• Coalescence (physics)

References

External links

• Ostwald Ripening a 3D Kinetic Monte Carlo simulation

Separation processes
Processes	Absorption Acid-base extraction Adsorption Chromatography Cross-flow filtration Crystallization Cyclonic separation Dialysis (biochemistry) Dissolved air flotation Distillation Drying Electrochromatography Electrofiltration Filtration Flocculation Froth flotation Gravity separation Leaching Liquid–liquid extraction Electroextraction Microfiltration Osmosis Precipitation (chemistry) Recrystallization Reverse osmosis Sedimentation Solid phase extraction Sublimation Ultrafiltration
Devices	API oil-water separator Belt filter Centrifuge Depth filter Electrostatic precipitator Evaporator Filter press Fractionating column Leachate Mixer-settler Protein skimmer Rotary vacuum-drum filter Scrubber Spinning cone Still Sublimation apparatus Vacuum ceramic filter
Multiphase systems	Aqueous two-phase system Azeotrope Eutectic
Concepts	Unit operation