Westinghouse J46
J46 | |
---|---|
| |
J46-WE-8 cutaway | |
Type | Afterburning Turbojet |
National origin | United States |
Manufacturer | Westinghouse Aviation Gas Turbine Division |
Major applications | F2Y Sea Dart F7U Cutlass |
Developed from | Westinghouse J34 |
The Westinghouse J46 was an afterburning turbojet engine that was developed to power several United States Navy aircraft in the 1950s. It was intended to power the improved, swept wing, F3D-3 Skyknight (swept-wing version[1] ultimately canceled). It also powered the F2Y Sea Dart and the F7U Cutlass jets, and Walt Arfon's Wingfoot Express[2][3] land speed-record car.
Development and Design
The J46 engine was developed as a larger, more powerful version of Westinghouse's J34 engine, about 50% larger. The Westinghouse model number was a continuation of the "X24C" series of the J34. The model number assigned was X24C10, even though the J46 differed in many design features from the smaller J34. It was seen as a lower development risk than the J40 which was in parallel development at the same time. The development program ran into many problems with this engine, including the original electronic control system, compressor/turbine mismatches, combustion instability and control issues at altitude leading to compressor stalling The produced -8, -8A and -8B engines were all derated from the original design specification on both thrust and specific fuel consumption.[4]
The engine featured a 12-stage compressor that was driven by two turbine stages on a single shaft. Early development engines also featured an afterburner which was a simple "eyelid" design that was actuated by long control rods that ran the length of the engine. By the time the engine reached production, the nozzle design had been changed to an iris type "petal" design activated by the same long control rods now attached to a ring that ran on rollers. Pulling or pushing on the rods moved the ring back and forth with the iris opening or closing. The original design using the electronic control system would have featured a fully controllable A/B thrust from minimum to maximum but this was abandoned when the electronic control could not be brought to acceptable levels of reliability. The final A/B was an "ON/OFF" unit.
Variants
![](../I/m/Engine_maintenance_on_F7U_on_USS_Hancock_(CVA-19)_1957.jpg)
- J46-WE-3: 3,980 lbf (18.15 kN) thrust[5] Was to be used the Douglas X-3 "Stiletto". Failed to exit testing due to thrust shortfalls.
- J46-WE-4/-10: 3,9800 lbf (20.02 kN) thrust[5] The non-A/B version of the J46-WE-2/-8B. Intended for the Douglas F3D-3 SkyKnight but did not go into production because of schedule slippage and the F3D-3 cancellation.
- J46-WE-8A/B This variant powered the F7U-3 Cutlass and produced 5,500/5,800 lbf of A/B thrust. All -8A engines were upgraded to the -8B build standard after being produced. The F7U-3 was equipped with two J46-WE-8B turbojets giving a 680 mph (1,095 km/h) max speed.[6] This variant also powered the Harvey Hustler, a speed boat designed to go faster than 275 mph.[7]
- J46-WE-8: 3,980 lbf (20.46 kN) (5,800 lbf (27.13 kN) thrust with afterburner)[5] This variant powered both the F7U-3 and F7U-3M, the missile-capable Cutlass.
- J46-WE-12:This variant powered the F2Y Sea Dart hydroski aircraft. Basically identical to the -8/-8B, the aircraft was equipped with a fresh water spray system that flushed salt deposits out of the engine before takeoff and after shutdown.[8]
- J46-WE-18:This variant produced an increased 6,100 lbf (27.1 kN) of A/B thrust for the proposed A2U-1 attack aircraft, an attack variant of the F7U. This variant was canceled with the aircraft program.[8][9]
Specifications (J46-WE-8)
General characteristics
- Type: Afterburning Turbojet
- Length: 198 in (5.0 m)
- Diameter: 28 in (0.86 m)
- Dry weight: 2116 lb (952.5 kg)
Components
- Compressor: Single-Spool, 12-stage Axial
- Combustors: Annular, walking stick evaporators
- Turbine: 2-stage turbine
- Fuel type: JP-4, JP3 or avgas
- Oil system: wet sump in accessories gearcase, 3.25 US gal
Performance
- Maximum thrust: 3,980 lbf (21.4 kN) dry, 5,800 lbf (26.7 kN) afterburning. A "modernization" program replaced many parts on production J46-WE-8B and J46-WE-8 engines to give higher thrust and longer turbine life. On tests fully modernized engines approached 6,000 lbs of thrust. No updated specification was issued to cover such engines. Thrusts and SFC's here are for the official approved specification guarantees.
- Overall pressure ratio: 5.32:1
- Air mass flow: 73 lb/sec
- Turbine inlet temperature: 1,525F
- Fuel consumption: 1.088 military dry / 2.40 in A/B
- Thrust-to-weight ratio: 2.3:1 dry, 2.9:1 afterburning
Survivors
- Carolinas Aviation Museum, - four units in storage, three came from Florida. Also have two afterburner units, not attached to engines.
- Wings Over the Rockies Air and Space Museum, - two units including a -8 cutaway on display (see photo above)
- Project Cutlass, Phoenix Arizona, - six units, including two airworthy engines with afterburners
- Hiller Aviation Museum, cutaway exhibit engine
- Smithsonian National Air and Space Museum, Exhibit 1971-0911, J46-WE-8B, Serial WE405773, 15 total running hours, including acceptance testing and 3 flights in an F7U-3. In storage.
- Green Mamba dragster owned by Doug Rose in Tampa, Florida
- No -1, -2, -3, -5, -12 or -18 engines are known to exist
See also
- Related development
- Related lists
References
Notes
- ↑ Vectorsite.net: F3D Skynight
- ↑ Air & Space Magazine,March 01, 2009, Oldies and Oddities: The Bonneville Jet Wars
- ↑ Air & Space Magazine,March 01, 2009, Oldies and Oddities: The Bonneville Jet Wars Photos
- 1 2 Aero Engines 1954 (1954). Flight. 9 Apr 1954. pg 461
- 1 2 3 Roux 2007, pp. 237–238.
- ↑ History Wars Weapons: F7U Cutlass
- ↑ Cady, Steve (1965). Californians Seek Water Speed Mark. The New York Times, 28 Nov 1965. pg. S11.
- 1 2 Aero Engines 1956 (1956). Flight. 11 May 1956, p. 596
- ↑ Westinghouse J46 Axial Turbojet Family, Paul Christiansen, Bleeg Publishing, 2016. ISBN 978-0692764886
- ↑ Westinghouse Turbojets (1953). Flight. 13 Nov 1953. pg 642
Bibliography
- Roux, Élodie. Turbofan and Turbojet Engines: Database Handbook. Raleigh, North Carolina: Éditions Élodie Roux, 2007. ISBN 978-2-9529380-1-3.