Solid ground floor

Detail of solid ground floor and foundation.

Finishes applied to solid ground floors in construction

Cement screed: The concrete floor may be topped with a 25 mm thick cement and sand screed trowelled to a smooth finish. The usual mix is 1:3 and a colouring agent may be added to the mix to obtain a more attractive finish. The mix should be as dry as possible and the sand should be coarsely graded and clean to avoid shrinkage and cracking which might occur with a wet mix. The floor finish is carefully cured after laying.

Granolithic: Granolithic is composed of cement and fine aggregate mortar, the aggregate being granite chippings, which will give the hard wearing quality of the finish. It will be laid with screed, trowelled or floated to an even and fine finish. Granolithic paving will be suitable in areas which are to receive hard wear although its appearance would not normally be suitable for internal domestic work.

PVC tiles: Polyvinyl chloride tiles -These are another commonly used floor finish. After the floor has been laid with screed, these tiles are fixed with adhesive. They are attractive, smooth and cool, and damage can be repaired very easily as they are made in small square size, usually 150 mm to 225 mm. Though due to poor workmanship and dust this type of floor finish fails through lifting.

Terrazo: Terrazo consists of a coloured element binder or matrix and marble chips mixed to specified proportions. The finish is hardwearing, attractive and resistant to chemical attack. Ebonite strips divide the terrazo into bays to avoid shrinkage and expansion.

References

    Further reading

    This article is issued from Wikipedia - version of the 4/13/2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.