Short Springbok

Springbok I / II / Chamois
Springbok I prototype (J6974), Martlesham Heath 1923
Role Two-seater biplane
Manufacturer Short Brothers
Designer Oswald Short
First flight S.3 (Springbok I): 19 April 1923
S.3a (Springbok II): 25 March 1925
S.3b (Chamois): 14 March 1927
Primary user Aeroplane and Armament Experimental Establishment (A&AEE), Martlesham Heath
Number built 2 (S.3 Springbok I)
3 (S.3b Springbok II)
1 (S.3b Chamois)


The Short Springbok was a two-seat, all-metal reconnaissance biplane produced for the British Air Ministry in the 1920s. Altogether six aircraft of the Springbok design were built but none entered service with the armed forces.

Design

The Springbok fuselage was of streamlined monocoque construction mounted onto the lower wing and almost filling the gap between the upper and lower wings. The wings were single-bay, of unequal span and unequal chord, constructed of steel spars with an aluminum (S.3/3a Springbok) / fabric covering (S.3b Chamois). The ailerons were on the upper wing only. The crew of two sat in tandem open cockpits, with a cutout in the upper mainplane for the pilot's head; the observer/gunner sat behind the pilot, just behind the upper wing. The tail unit comprised a braced monoplane tail near the fuselage top with a single fin and rudder. The undercarriage was of the cross-axle type, situated under the nose and complemented by a tailskid at the rear.

History

The Springbok traces its history from the pioneering, all-metal Short Silver Streak, which was exhibited at the Olympia Aero Show in 1920. The Air Ministry had purchased the Silver Streak and subjected it to structural tests for two years at R.A.E., Farnborough. When in due course the Air Ministry issued a "Bristol Fighter-replacement" Specification 19/21, Short Brothers contracted to deliver two S.3 Springbok I two-seat reconnaissance biplanes (J6974 and J6975). On 30 November 1923, the second of the two prototypes, J6975, crashed near Martlesham when it spun in shortly after takeoff, killing the pilot. The cause was diagnosed as rudder blanking during spinning and a new wing design was prepared for the Springbok Mk. II, of which six examples - later reduced to three - were ordered in 1924.[1]

Powered by a 400 hp Bristol Jupiter IV radial engine, the S.3 Springbok I was a truly all-metal aircraft, with a duralumin monocoque fuselage and two-bay, equal-span wings. The strength/weight factor of the mainplanes was disappointing and the Air Ministry ordered three more Springboks with lighter, fabric-covered wings attached directly to the lower fuselage and a redesigned tail assembly. The first of these S.3a Springbok IIs (numbered J7925-J7927) was flown by Shorts' Chief Test Pilot J. Lankester Parker at the Isle of Grain on 25 March 1925.

The Springbok at Martlesham with fabric-covered wings

The S.3b Chamois was produced in response to Specification 30/24 (as was the Vickers Vespa). The airframe of the first Springbok II (J7295) was adapted to take the more powerful 450 hp Jupiter VI. Its first flight took place at Lympne Aerodrome on 14 March 1927, also flown by Lankester Parker.

Short Chamois

The tests, from 27 April 1927 by Aeroplane and Armament Experimental Establishment (A&AEE), then at Martlesham Heath, determined that its performance was disappointing and the only prototype was scrapped.

Operators

 United Kingdom

Specifications (Springbok I)

Data from Shorts Aircraft since 1900[2]

General characteristics

Performance

Armament

See also

Related development


Related lists

References

  1. ↑ Mason, Francis K., "The British Fighter since 1912", Naval Institute Press, Annapolis, Maryland, 1992, Library of Congress card number 92-63026, ISBN 1-55750-082-7, page 160.
  2. ↑ Barnes 1967, p. 173.
Wikimedia Commons has media related to Short Springbok.
This article is issued from Wikipedia - version of the 5/10/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.