NAD 3020

The NAD 3020 integrated amplifier

The NAD 3020 is an iconic stereo integrated amplifier by NAD Electronics, considered to be one of the most important components in the history of high fidelity audio.[1] Launched circa 1978, this highly affordable product delivered a good quality sound, which acquired a reputation as an audiophile amplifier of exceptional value. By 1998, the NAD 3020 had become the most well known and best-selling audio amplifier in history.[2]

History

Launched circa 1978–79[2] in an era where the principal preoccupation of hi-fi manufacturers was power output, the sub-£80 (US$135) low-powered solid state amplifier, created and marketed by a then little-known manufacturer,[3] very rapidly acquired a reputation for excellent sound quality and exceptional value.[2][4] Stereophile magazine called the NAD 3020 "ridiculously inexpensive".[5] It was the first integrated amplifier built with convincing ability to drive difficult loudspeaker loads, and a sound quality that far exceeded other integrated amplifiers at its price point for the time.[2]

In an era when the NAD's rated power output of 20 watts per channel continuous into 8 ohms was considered anaemic,[3] the manufacturer claimed it could deliver much stronger power output into lower impedances under dynamic conditions (music or peak power output).[6][7] Indeed, it is capable of delivering 40 watts into 8 ohm, 58 watts into 4 ohm, and 72 watts into 2 ohm loads for a limited time if pushed.[8] The amplifier's main appeal was its inherent musicality, its ability to drive difficult speaker loads, and to allow audiophile grade source components to excel.[2][3] Launching the product in the US at the Consumer Electronics Show, the company wired up a battery of loudspeakers in a way which presented an impedance of 1.1 ohm, and the amplifier experienced no problems.[8] Similarly, at its London launch, NAD successfully demonstrated it driving the Linn Isobarik, whose impedance characteristics are known to be very challenging for amplifiers.[9] It was the best-known and best-selling amplifier in the annals of hi-fi.[2] The NAD 3020 revolutionised the amplifier segment of the hi-fi industry.[3]

Design principles

Bjørn Erik Edvardsen, NAD's director of advanced development,[1] set out to create an "inexpensive amplifier ... easily capable of driving the very best loudspeakers".[7] NAD eschewed the laboratory test equipment thinking, which was prevalent at the time, and instead aimed to make their amplifiers capable of properly driving "real loudspeakers" under realistic conditions. This paradigm shift gave rise to an amplifier that cost less and sounded better.[10][11] NAD was able to achieve a low cost base by foreign manufacture. The company designed the product in Europe and had it produced in factories in Taiwan – it was one of the first manufacturers to de-localise production to Asia.[12]

The design, and models following it, included "soft-clipping circuitry" that protects against over-driven signals, connections that allow splitting of the power amplifier section from the preamplifier, a button to bypass tone controls, and "Full Disclosure" power ratings measuring output power under real-world loads.[13]

Audio circuitry

The NAD 3020 has four inputs that can be switched via the front panel – Aux, Tuner, Phono, Tape. The manufacturer claims the phono input, which can also be used with high-output moving coil cartridges, contains a 6-transistor circuit "engineered for extremely low noise and nearly distortion-free performance". Reviewers note the pre-amplifier's "decent moving-magnet phono stage".[2][12][8] The amplifier is bandwidth-limited, incorporating infrasonic and ultrasonic filters to supposedly reduce the effects of non-musical signals such as acoustic feedback, disc warps and electromagnetic interference on the musical signals.[7]

The amplifier has bass and treble tone controls which, according to the manufacturer, are "tailored for musically effective response in the high and low frequencies without altering the critical mid-range tonal balance". A loudness switch – de rigueur in that era – boosts upper and lower frequencies; a "mute" switch reduces volume by 20 dB for low-level listening.[7] There is also a headphone socket mounted onto the front panel.

According to the manufacturer, the NAD 3020 is a high voltage design that uses the same large powerful output transistors that "other manufacturers employ in their '60-watt' amplifiers", enabling the amplifier to deliver power headroom for musical transients.[7] Although the "Soft Clipping" circuitry limits the output voltage so that the transistors do not distort when driven beyond its rated power,[7] Lucio Cadeddu of TNT considers this protection and the tone-shaping circuitry to be unnecessary and advises users to avoid them "like the plague".[2]

The innovative split of pre- and power-amplifier sections allows the use of the pre-amp stage to drive multiple power amplifiers in parallel, or use long signal cables to connect to remote power amplifiers or powered speakers.[14] This faculty became hugely popular with audiophiles, who would seek to isolate this "remarkably fine-sounding preamp section", to use with one or more external power amplifiers.[12][11]

Power source

The amplifier has what the manufacturer calls a "dual-mode power supply", where the output stage is only loosely regulated, so it is free to supply the high voltages needed for musical transients and the large currents at lower voltages needed for driving low-impedance loads in the power amplifier circuitry. The design also incorporates a separate regulated power supply circuit, fed from a secondary winding on the transformer, dedicated to the pre-amplifier and tone control stages. It is thus claimed that intermodulation distortion and blurring of the stereo image due to power supply functioning cannot occur.[7]

Styling

The styling of the NAD 3020 resembled that of other budget amplifiers of the time, and it was available in charcoal grey or silver. Stereophile commented that it was "inexpensive and looked it".[12] Although Cadeddu criticised the amplifier as "ugly, cheap and with a poor level of finishing", he said that "the components used were fair but, clearly, the man behind its design knew what he was doing pretty well".[2]

Reception

The highly popular NAD 3020 is considered one of the most important hi-fi components in the history of home audio.[1] Sonically, it benefited from a design error where crosstalk between left and right channels presented better detail and more ambiance; the error was corrected in a later guise.[8] Its sound is described by reviewers as dark and warm, with a "sweet and sensual midrange";[2][3] some reviewers observed a very noticeable rolling off at frequency extremes that may detract from sonic neutrality, and that its soundstage lacked precision[2][3] but it was universally praised for its value for money.[2][3][15] The amplifier was a hot seller,[1][6] and the NAD 3020 alone achieved a record 1.1 million units in its lifetime. The figure would be much higher if the sales of other amplifiers derived directly from its design are included.[16] The quality made possible at a £79 (US$133) price tag opened up the market for budget yet quality amplifiers, and spawned similarly low-priced competitors such as ARCAM Alpha, Rotel 840, Mission Cyrus I, Pioneer A400, Denon PMA 350 and Marantz PM40 SE.[9] In 2002 it ranked No. 19 in list of "The Hot 100 Products" by Stereophile.[1][5] In 2011, The Absolute Sound placed it at No. 9 in their list of "The Ten Most Significant Amplifiers of All Time".[16] The Absolute Sound remarked that this "iconic gem could embarrass amplifiers costing 10 times more with its big, warm and detailed sound and best of all, its affordable price made it available to a wider audience."[3][10]

A retrospective review by Chris Martens said that the 3020 was not perfect, and while it may have been surpassed by other components according to other performance criteria individually, it was "better than any $200 integrated amp had any right to be".[15] Martens complimented the quality of the electronic circuit design, noting in particular that the phono stage "sounded clearer and better balanced than many dedicated phonostages of the day".[15]

Spin-offs and legacy

The newly launched NAD D 3020 hybrid digital amplifier in a shop in 2013

The NAD 3020 sold half a million units in the first three years of its life, and the second-generation NAD 3020A replacing it, which corrected some minor design errors, proved even more popular than its predecessor.[8]

Variants included NAD 3020B, NAD 3020E. An "almost identical" audiophile version dubbed NAD 3120, stripped of tone controls and with higher quality loudspeaker binding posts, was released.[9][17] The NAD 3020i is an "improved" version of the NAD 3020[18] that retailed at £149 (US$250) when it was launched in 1991.[14][19] The NAD 7020 receiver (tuner-amplifier), that included the amplification circuitry of the NAD 3020, received a mixed reception due to severe reliability issues.[8] Following its release, and upon realisation that the product was much sought after for its pre-amplifier section, a preamp version of the NAD 3020 was released under the name NAD 1020.[3][6]

In 2013, the 40th year of the company, NAD launched a range of digital products, including a digital amplifier bearing the name NAD D 3020.[10]

References

  1. 1 2 3 4 5 Mejias, Stephen (29 July 2011) "The Entry Level #7". Stereophile. Page 3 Archived from the original on 19 November 2013.
  2. 1 2 3 4 5 6 7 8 9 10 11 12 Cadeddu, Lucio (1998). "NAD3020". TNT Audio. Archived from the original on 19 November 2013.
  3. 1 2 3 4 5 6 7 8 9 "Hi-Fi That Rocked: NAD 3020 Integrated Amplifier", Hi-Fi Choice, May 2006 (quoted on the NAD website)
  4. ↑ R.S. Murthi (9 March 2000). "Sounding out NAD". New Straits Times. Archived by Highbeam.
  5. 1 2 Atkinson, John (17 November 2002) "40 years of Stereophile: The Hot 100 Products". Stereophile. Page 6 Archived from the original on 19 November 2013.
  6. 1 2 3 Guttenberg, Steve (16 July 2011). "NAD 3020: Vintage hi-fi that still sounds great". CNet. Archived from the original on 19 November 2013.
  7. 1 2 3 4 5 6 7 "3020 series 20 Integrated Amplifier". NAD Electronics. Data sheet accessible through NAD 3020 product page.
  8. 1 2 3 4 5 6 Guttenberg, Steve (2011). "Old School – NAD 3020 Integrated Amplifier". Tone Audio.
  9. 1 2 3 Husband, Geoff (1999). "HiFi buying guide – Part 2: amplifiers". TNT Audio. Archived from the original on 19 November 2013.
  10. 1 2 3 "NAD Announces Trio of Groundbreaking Digital Audio Products". The Absolute Sound, 3 May 2013. Archived from the original on 19 November 2013.
  11. 1 2 Duke, Kenneth M. (1 April 1999). "NAD 317 Integrated Amplifier". Sensible Sound. Archived by Highbeam.
  12. 1 2 3 4 Fremer, Michael (21 January 2007) "NAD Master Series M3 integrated amplifier". Stereophile. Archived from the original on 19 November 2013.
  13. ↑ Garcia, Wayne (29 November 2008). "NAD C356BEE Integrated Amplifier". The Absolute Sound. Archived from the original on 19 November 2013.
  14. 1 2 "NAD3020". Hifi Engine. Archived from the original on 19 November 2013.
  15. 1 2 3 Martens, Chris. "NAD3020 – The Little Amp That Put High-End Sound Within Everyone's Reach". The Absolute Sound (2004). Courtesy link from Celestial Sound
  16. 1 2 Breuninger, Gader, Greene, Harley, Olsher, Seydor and Valin. "The Ten Most Significant amplifiers of all Time". The Absolute Sound/Hi-Fi+ Guide to Preamplifiers and Power Amplifiers (2011).
  17. ↑ "NAD 3120 Stereo Integrated Amplifier". NAD Electronics. Data sheet accessible through NAD 3120 product page.
  18. ↑ "NAD3020". Audio4maniacs.co.uk. Archived from the original on 19 November 2013.
  19. ↑ John H. Darko (8 January 2014). "NAD D 3020 review (Part 1 – vs. NAD 3020i)". Digital Audio Review.

External links

This article is issued from Wikipedia - version of the 1/16/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.