Larpool Viaduct

Larpool Viaduct
Carries Single track railway line
Characteristics
Total length 305 yd (279 m)
Height 120 ft (37 m)
Number of spans 13
History
Opened c. 1885

Larpool Viaduct, also known as the Esk Valley Viaduct is a 13 arch brick viaduct built to carry the Scarborough & Whitby Railway over the River Esk, North Yorkshire, England.

History and description

The viaduct was constructed for the Scarborough and Whitby Railway to carry a single track line over the River Esk and valley near Whitby, as well as crossing the Esk Valley Railway, and Whitby, Redcar and Middlesbrough Union Railway. Due to its situation close to the sea the design avoided the use of iron, using brick and cement construction; the design was based on the Saltburn Viaduct.[1] Construction began in October 1882 and was complete by October 1884; two men fell from the piers during construction, but recovered.[2] The resident engineer was Charles Arthur Rowlandson, the contractors were John Waddell and Sons.[3]

The viaduct was a 13 arch structure, 305 yd (279 m) long, with the rail level reaching 120 ft (37 m) high. The foundations on land were excavated to the level of rock, and formed from slag based cement. The river foundations were excavated in brick lined wells. The river foundation excavations were complicated by large oak trees found embedded in the river, which required divers for manual removal.[4] Piers 5,7,8 and 9 had triple foundations, connected above the water level by two semicircular arches.[5] Three of the piers in the river are skewed so as not to deflect the tidal flow (the River Esk is tidal as far as Ruswarp upstream).[6][7]

The main arches were 55 to 65 ft (17 to 20 m) wide, and 27 ft 6 in (8.38 m) high, made of bricks seven deep, 2 ft 9 in (0.84 m). The width between the parapets was 14 ft 6 in (4.42 m) on straight sections.[8]

Services on the line ended in March 1965 as a result of the Beeching Report.[9]

The viaduct became grade II listed in 1972.[10] In 2000 much of the former line and the viaduct were opened to the public. By 2006 parts of the brickwork had become unsafe due to spalling, and the parts of the outer layer were replaced.[9] As of 2012 the viaduct is part of the 'Scarborough to Whitby Rail Trail', also promoted as the "Scarborough to Whitby Cinder Track",[11] a cycle route.[12]

The viaduct is mentioned in Bram Stoker's 1897 novel Dracula:

The little river, the Esk, runs through a deep valley, which broadens out as it comes near the harbour. A great viaduct runs across, with high piers, through which the view seems somehow further away than it really is.
Dracula, Chap.6, Mina Murray's Journal.[13][10]

The viaduct is featured in the December 2007 episode of Heartbeat entitled "Another Sleepy, Dusty, Delta Day".

References

  1. Fox 1886, pp. 303–4.
  2. Fox 1886, p. 309.
  3. Fox 1886, p. 311.
  4. Fox 1886, pp. 304–5.
  5. Fox 1886, pp. 306–7.
  6. "Larpool Viaduct". Forgotten Relics of an Enterprising Age. Retrieved 28 November 2015.
  7. "River Esk (Yorkshire) Tideway Byelaw Report" (PDF). North York Moors. Environment Agency. p. 7. Retrieved 28 November 2015.
  8. Fox 1886, pp. 307–8.
  9. 1 2 Garrity, Stephen W. "THE REHABILITATION OF A VICTORIAN CLAY BRICK RAILWAY VIADUCT" (PDF). Proceedings of 8th International Conference on Short and Medium Span Bridges.
  10. 1 2 Historic England. "Viaduct at Larpool (1366577)". National Heritage List for England. Retrieved 5 December 2012.
  11. "The Cinder Track". www.gatewaywhitby.co.uk. Retrieved 17 August 2012.
  12. "Scarborough to Whitby railway (the 'Cinder Track')". www.northyorkmoors.org.uk. Retrieved 25 November 2016.
  13. Stoker, Bram (1897). "6". Dracula. pp. 1–19. Retrieved 28 November 2015.

Sources

Wikimedia Commons has media related to River Esk Railway Viaduct, Whitby, North Yorkshire.

Coordinates: 54°28′28″N 0°37′06″W / 54.474500°N 0.618450°W / 54.474500; -0.618450

This article is issued from Wikipedia - version of the 11/25/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.